Retaining Wall Calculator
Enter the length and the exposed height of your wall. The calculator buries the first course, sizes the gravel base and the drainage column behind the blocks, and lays out the drain pipe and filter fabric — then turns all of it into a cut list in the units the store sells.
Materials
| wall blocks | 74 | |
|---|---|---|
| cap blocks | 15 | |
| crushed stone base, compacted | 0.94 | cu yd |
| clean drainage stone (3/4 in.) | 1.73 | cu yd |
| 4 in. perforated drain pipe | 23 | ft |
| 4 in. drain tees | 1 | |
| 4 in. end caps | 2 | |
| 4 in. outlet grates | 1 | |
| non-woven filter fabric | 20 | sq ft |
Cut list
Masonry
- 74wall blocks
- 15cap blocks
Stone and gravel
- 0.94 cu ydcrushed stone base, compactedbuy 1.4 tons, or 51 x 0.5 cu ft bag
- 1.73 cu ydclean drainage stone (3/4 in.)buy 2.57 tons
Drainage
- 23 ft4 in. perforated drain pipebuy 3 x 10 ft stick
- 14 in. drain tees
- 24 in. end caps
- 14 in. outlet grates
Filter fabric
- 20 sq ftnon-woven filter fabricbuy 1 x 150 sq ft roll
Cuts to make on site
- Cut 2 blocks in half (running bond: every second course starts and ends with a half block)
- Wall blocks
- Cap
- Compacted base
- Drainage stone
- Cap soil
- Drain pipe
- Filter fabric
- Finished grade
- Retained soil
Calculation steps
- Buried height30 in exposed + 6 in buried36 in total height
- Coursesceil(36 in / 8 in)5 courses
- wall blocksceil(240 in / 18 in) x 5 courses + 5% waste74 blocks
- cap blocksceil(240 in / 18 in) + 5% waste15 caps
- crushed stone base, compacted240 in x 24 in x 6 in x 125% compaction0.94 cu yd
- clean drainage stone (3/4 in.)240 in x 12 in x 28 in x 100% compaction1.73 cu yd
- 4 in. perforated drain pipe20 ft along the wall + 1 outlet x 36 in stub23 ft
- non-woven filter fabric240 in x 12 in over the stone20 sq ft
How the quantities are worked out
Every step is shown under the results in the calculation steps panel, so you can check the arithmetic. These are the assumptions behind it.
Buried course and block count
10% of the exposed height is buried, with a 6 in. minimum, and the total is rounded up to whole courses. Blocks are counted per course and per wall length, a running bond adds the half blocks at the ends, and the waste allowance you choose is added before rounding up.
Gravel base
A compacted crushed-stone base 6 in. deep, 6 in. wider than the blocks at the front and at the back. Compacted stone takes up less room than loose stone, so 25% is added to the volume, and the loose volume is converted to tons at 1.48 tons per cubic yard.
Drainage column, pipe and fabric
Clean drainage stone fills the space behind the blocks to 24 in. from the face of the wall, and never less than 12 in. behind the back of the blocks, up to 8 in. below the top where a layer of soil caps it. A 4 in. perforated pipe runs along the bottom of the stone with an outlet at least every 50 ft, each with a 36 in. stub to daylight.
Filter fabric covers the top of the stone. If your backfill is clay or silty soil, add the second strip between the stone and the soil. Fabric comes in 3 ft x 50 ft rolls, and each seam is overlapped by 12 in.
What this calculator does not do
It estimates materials. It does not check whether a wall will stand up, and it does not replace your block manufacturer's installation guide or your local building rules. Geogrid for taller walls is not included yet.
Frequently asked questions
Why do I need a drain pipe?
Water is the most common reason a block retaining wall bulges or tips. Soil that stays wet pushes on the wall much harder than dry soil, and dry-stacked blocks cannot hold that back for long. A perforated pipe laid at the bottom of the drainage stone collects the water and carries it out through outlets at the ends of the wall or every 50 ft or so along it. The calculator adds the pipe run along the wall plus a short stub at each outlet, and lists the tees, end caps and outlet grates that go with them.
What's filter fabric for?
Filter fabric keeps soil out of the drainage stone. Without it, fine soil washes down into the gaps between the stones over a few seasons until the stone stops draining. The calculator always includes a strip laid over the top of the stone, under the last few inches of soil. If your backfill is clay or silty soil, tick the second fabric option to also line the back of the stone where it meets the soil. Each roll seam is overlapped by 12 in., and that overlap is included in the square footage.
How much of the wall should be buried?
Most block manufacturers ask for about one inch of buried wall for every eight to ten inches of exposed wall, and never less than about 6 in. The calculator buries 10% of the exposed height with a 6 in. minimum, then rounds up to whole courses, so the first course always sits below the finished grade. Your block manufacturer's instructions take priority if they ask for more.
How much gravel do I need under a retaining wall?
The calculator uses a compacted base 6 in. deep that runs 6 in. past the front and the back of the blocks. Crushed stone shrinks when you compact it, so it orders 25% more loose stone than the finished base volume, and converts that loose volume to tons for the cut list. Taller walls and soft soils often need a deeper base; follow your block manufacturer's chart if it differs.
How do I read the cut list?
The cut list groups everything by the aisle you will find it in: masonry, stone and gravel, drainage, and filter fabric. Each line shows the quantity the wall needs and, in brackets, what to put in the cart, such as sticks of pipe, rolls of fabric, tons of stone or pallets of block. The last block lists the cuts to make on site. Copy it, print it or download the PDF and take it to the store.